While it’s the source of life, water is the enemy of a homeowner facing plumbing problems. A plumbing malfunction could literally ruin a house and cost a lot of money. The good news is there are steps that every homeowner can take to stop plumbing nightmares from coming to life, and for fixing them before they get out of control.
You don’t want to end up with frozen pipes, so take preventive action, such as wrapping outside pipes with insulation, and keeping indoor temperatures above freezing at all times. The pipes will be able to freeze if the temperature surrounding the pipes drops below freezing. If they do freeze, you are looking at some time before they can thaw out, thus you will have to wait for running water. However, frozen pipes commonly break or crack pipes, leading to flooding and costly repairs.
Do not pay your plumber until they finish the job. A plumber might ask you for part of the money before starting the job but you should never pay more than half. Agree with the plumber in advance on the job and payment.
If you have a clogged toilet with a low water level and a plunger isn’t doing the job, it’s time to try adding a bucket of lukewarm water to the toilet from a around three feet or higher. You could repeat this process again if the water in the toilet bowl gets low.
Never use your bare hands to try fixing your garbage disposal. Even when they are turned off, disposals can be very dangerous. Locate a diagram of the garbage disposal, or some sort of troubleshooter, online.
Every so often, inspect the floor around your toilet and see if it has gone soft. You can check for softness or weakness in the floor by placing one foot on each side of the toilet and rocking back and forth. You can save a lot if you catch these issue sooner.
If you have well water and discover orange or pink discoloration on your bathtub or sink, you probably have iron in your water supply. A water softener is the easiest way to solve hard water problems relating to rust, but you can also consult a plumber if you are unsure.
Look at the overflow holes to ensure they aren’t clogged up. Overflow holes exist to act as a double check in case of an overfilling sink. That may seem unimportant – but it will become a problem if they are clogged. As you routinely look for things needing attention, check to be sure that the overflow holes are clear and unblocked.
Always remember to keep your dryer’s lint trap clean. This saves you from potential problems, including the prevention of fires. Always check your lint trap for damage, such as holes or tears. This could allow lint to enter your pipes, leading to clogs or other plumbing complications.
Good management and prevention can help you save money on plumbing. One of the major repairs is clogs. Drains are frequently clogged by hair. Screens and drain covers are great ways to stop hair from going down your drains. You can remove hair much easier from a screen as opposed to getting it out of the inside of a pipe.
Try to avoid the use of dry cleaners as often as you can. Corrosive chemicals erode the metal pipes slowly. If your drain is clogged, hire a pro to figure out the problem.
The clean out plug can sometimes be difficult to remove, and if you are having problems, there are two approaches to fixing this problem You can loosen the fitting around the plug using a hammer and chisel. Another option is chiseling through the relevant clean out plug.
As it is with anything, good preparation and education are keys to avoiding problems, and this holds true with plumbing as well. A homeowner is likely to make good decisions and avoid plumbing disasters if he bothers to learn some things about the subject. It is best for one to do one’s research and try fixing one’s plumbing issues before things get worse.